Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

!

{N-&,) Check the following items.

CHECK IneuT siGNAL OF

Harness continuity between @®

FLUID TEMPERATURE

A/T control unit and terminal SENSOR. cord assembly (Main harness)

1. Ge pa

2. Check voltage between A/T control unit terminal 1a and it ground while warming up A/T. Voltage: A/T control unit Cold (20°C (68°F)}] > terminal Hot [80°C (176°F)]:

1.56V > 0.45V OK. ¥ N.G_ | 1. Perform A/T control unit Perform self-diagnosis after input/output signal inspection. driving for a while. 7

2. If N.G., recheck A/T control OK. unit pin terminals for damage ¥ SATT7S0B or connection of A/T control

INSPECTION END

unit harness connector.

ENGINE REVOLUTION SIGNAL CIRCUIT CHECK

N.G. _| Check ignition signal circuit for Perform self-diagnosis (Mode tgnition

"| engine control. — Refer to section

ee Ill) for engine control, Check coil EF & EC. ignition signal circuit condition. eer ‘ O.K. Resistor 1 Check the following items. N.G. |

CHECK INPUT SIGNAL.

@ Harness continuity between

1. :

A/T control unit and ignition

75 xo) A/T control unit coil. © SATG624B ® Resistor

2. Check voltage between A/T

amet

@ Ignition coil — Refer to

control unit terminal @5) and

ee section EF & EC, ground, fais ae HS. Voltage: 9.5 -12V en ta COWMECT O.K. A/T control unit terminal ¥ | 1. Perform A/T control unit |N-G. Perform self-diagnosis again after

input/output signal inspection.

“| driving for a while. ge

9. 1fN.G., recheck A/T control OK. aS unit pin terminals for damage + or connection of A/T control

INSPECTION END

unit harness connector. SAT7518 AT-43

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.