REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
REPAIR FOR COMPONENT PARTS
REPAIR FOR COMPONENT PARTS
Oil Pump (Cont'd)
c. Install O-ring and friction ring on cam ring. @ Apply petroleum jelly to O-ring.
d. Assemble cam ring, cam ring spring and spring seat. Install spring by pushing it against pump housing.
sot aes
e. While pushing on cam ring install pivot pin. Feet sei er = Bee a oe
3. Install rotor, vanes and vane rings. @ Pay attention to direction of rotor.
4. Install oil pump housing and ail pump cover.
a. Wrap masking tape around splines of oil pump cover assembly to protect seal. Position oil pump cover assembly in oil pump housing assembly, then remove masking tape.
b. Tighten bolts in a criss-cross pattern.
AT-94 ,
Parts & tools for this job For Nissan 180SX
- PARTTransmission filter kitSearch: Nissan 180SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.