Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

Throttte sensor

THROTTLE SENSOR CIRCUIT CHECK

Perform self-diagnosis (Mode N.G. ,| Check throttle sensor circuit for {

TH) for engine control,

. engine control. — Refer to sec-

tion EF & EC.

OK. | M— ECU, ‘y

CHECK INPUT SIGNAL.

N.G. | Check harness continuity ' 7

A/T contral unit

Q 10

unit regarding throttle sensor

1. “|

between E.C.U. and A/T control i = circuit. (Main harness) — SAT761A J ——

2. Check voltage between AIT 7 control unit terminals @) and (5) while accelerator pedal is a depressed slowly. i Voltage: Fully-closed throttle: \N

0.2 - 0.6V 7 Depress slowly Fully-open throttle: |

2.9-3.9V a (Voltage rises gradually in ; q 11?) response to throttle valve _ 1S, — opening.) ; a , CONNECT fs = {ok 7 a € > G B

Perform self-diagnosis again after

|N.G. -| 1. Perform A/T control unit

7 driving for a while. _ input/output signal inspection. 7 ‘: OK.

2. If N.G., recheck A/T control : ie + unit pin terminals for damage Ba rs) a ’

INSPECTION END

or connection of A/T control a unit harness connector.

u ie SAT739B

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.