Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

LINE PRESSURE SOLENOID CIRCUIT CHECK

Line pressure solenoid SOO | Terminal

CHECK GROUND CIRCUIT.

NG 1. Remove control valve assem-

cord assembly

1.7 bly. — Refer to “ON-VEHI-

CLE SERVICE".

& | Dropping 2, Check the following iterns. < | resistor

2. Disconnect terminal cord

©

Line pressure solenoid —

assembly connector in engine

Refer to “Electrical Com-

34 33 A/T control unit compartment. ponents Inspection’’.

3. Check resistance between ® Harness continuity of terminal SAT776A

terminal 64 and ground.

cord assembly

_| HR® A Resistance: 2.5 - 50 Sub- Wee) harness connector OK. 'B} | A DISCONNECT €) N.G ona |; |

CHECK POWER SOURCE

-7: 4) Check the following items. CIRCUIT. @ Dropping resistor — Refer to

1. “Electrical Components (it Inspection’. a : ® Harness continuity between

2. Disconnect A/T control unit

A/T control unit @3) and

16-pin connector. terminal cord assembly = SAT752B

3. Check resistance between

{Main harness)

1B]

terminal Oh and A/T control

unit terminal 63 . DISCONNECT = Resistance: 11.2 - 12.80

Weta“a €)

| OLK, Sub- = 8 harness G3 TY (E15) connector /

CHECK POWER SOURCE

NG. Repair or replace harness OR/L. CIRCUIT between A/T control unit 34

1. Ga and terminal cord assembly.

2. Check resistance between DRSCONMECT terminal 64 and A/T control

unit terminal 6).

co Resistance: Approximately 00 3433

3. Reinstall any part removed. OR/L A/T contral ir unit terminal LQ) OK. ¥ Perform self-diagnosis after NG. 1. Perform A/T control unit driving for a while. input/output signal inspection.

2. If N.G_, recheck A/T control OLK, SAT753B unit pin terminals for damage ¥ or connection of A/T control

INSPECTION END

unit harness connector. _

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.