Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

SHIFT SOLENOID B CIRCUIT CHECK

Shift solenoid B

N.G.

CHECK GROUND CIRCUIT.

1. Remove control valve assem- bly. — Refer to “ON-VEHI-

CLE SERVICE”,

Terminal

2. Check the following items. cord assembly @ Shift solenoid B — Refer to

2. Disconnect terminal cord 36 “Electrical Components assembly connector in engine A/T control unit Inspection’. compartment. ® Harness continuity of terminal

3. Check resistance between SAT7E7A

terminal eT and ground.

cord assembly —— Sub- Resistance: 20 - 300 harness connector O.K. 1B J a NG.

CHECK POWER SOURCE

Repair or replace harness CIRCUIT. between A/T control unit and terminal cord assembly. (Main harness)

2. Disconnect A/T control unit SAT742B 16-pin connector.

3. Check resistance between terminal and A/T control

unit terminal 68) :

DISCONNECT Resistance: va Approximately 00 . = 6 4, Reinstall any part removed. harness / yy OK. connector LiY Vv. N.G.- Perform self-diagnosis after

1. Perform A/T control unit driving for a while. input/output signal inspection.

2. IF NLG., recheck A/T control OK, unit pin terminals for damage Vv DISCONNECT - Uo) A €) or connection of A/T control

INSPECTION END

unit harness connector, Co

A/T control unit terminal

SAT743B

AT-39

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.