Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
AT automatic transmissionREPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Control Valve Upper Body (Cont’d)

b. Remove retainer plates while holding spring.

c. Place mating surface of valve facedown, and remove internal parts. @ If a valve is hard to remove, lightly tap valve body with a soft hammer. @ Be careful not to drop or damage valves, sleeves, etc.

SATB27A @ 4-2 sequence valve and relay valve are located far back in upper body. If they are hard to remove, carefully push them out using stiff wire. @ Be careful not to scratch sliding surface of valve with wire.

» Stiff wire SAT828A

AT-104

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.