REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
REPAIR FOR COMPONENT PARTS
REPAIR FOR COMPONENT PARTS
I
Control Valve Assembly (Cont’d)
DISASSEMBLY
1. Rernove solenoids.
a. Remove lock-up solenoid and side plate from lower body.
b. Remove O-ring from solenoid.
c. Remove line pressure solenoid from upper body.
d. Remove O-ring from solenoid.
e. Remove 3-unit solenoid assembly from upper body.
f. Remove O-rings from solenoids.
. d]snitt solenoid B }
Overrun clutch
2. Disassemble upper and lower bodies.
2 ze eae
- ees ast ‘Sh \.
a. Se ation! Py Place upper body facedown, and remove bolts, reamer bolts and support plates.
b. Remove lower body, separator plate and separate gasket as a unit from upper body. @ Be careful not to drop pilot filter, orifice check valve, spring and steel balls.
c. Place lower body facedown, and remove separate gasket and separator plate.
d. Remove pilot filter, orifice check valve and orifice check spring.
SATE704
AT-97
Parts & tools for this job For Nissan 180SX
- PARTTransmission filter kitSearch: Nissan 180SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.