REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
REPAIR FOR COMPONENT PARTS
REPAIR FOR COMPONENT PARTS
Low & Reverse Brake (Cont'd)
Low one-way clutch inner race @ Check frictional surface of inner race for wear or damage.
SATB7T7TA Install a new seal rings onto low one-way clutch inner race. _-| L_ Clearance Be careful not to expand seal ring gap excessively. | Seal ring LSE Measure seal ring-to-groove clearance. Inspection standard: Standard value
0.10 - 0.25 mm (0.0039 - 0.0098 in) yUf Allowable limit
0.25 mm (0.0098 in) if not within allowable limit, replace low one-way clutch inner L, f race,
- SATB78A ASSEMBLY
1. Install bearing onto one-way clutch inner race. EA © @ Pay attention to its direction — Black surface goes to rear side. @ Apply petroleum jelly to needie bearing.
SAT112B8
2. Install oil seal and D-ring onto piston. @ Apply A.T.F. to oil seal and D-ring. 5 Oil seal i
3. Install piston by rotating it slowly and evenly. @ Apply A.T.F. to inner surface of transmission case.
SAT8804
AT-122
Parts & tools for this job For Nissan 180SX
- PARTTransmission filter kitSearch: Nissan 180SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.