Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 5

vy O/D

SYMPTOM: There is large shock when changing from

=O= Throttle sensor circuit “ ~~ OFF Fluid temperature “N” to “R” range. sensor circuit Self-diagnosis Line pressure solenoid start

Yes _| Check damaged circuit. — Refer

Does self-diagnosis show damage

circuit

to “Self-diagnosis”.

to throttle sensor, line pressure

solenoid or fluid temperature sensor circuit? | No SAT758B N.G.

Check throttle sensor. — Refer

»|

Repair or replace throttle sensor,

Throttle sensor to section EF & EC.

to E.C.U.

Fluid temperature {ok ra] “t sensor

|N-G.| 4 Remove control valve assem-

Check line pressure at idle with

selector Jever in “D” range.

-

bly. — Refer to “ON-VEHI-

12 1S YW 1d A/T control unit

CLE SERVICE”.

— Refer to “PRESSURE a4 33 7

2. Check the following items.

TESTING”. Dropping resistor OK. @ Valves to control line pressure = Line pressure solenoid (Pressure regulator valve, SATOBSB modifier vaive, pilot valve and pilot filter} OAS tr. “ff / Line pressure solenoid @ Throttle sensor and --

throttle valve switch

mad 4 ¥

NG. »| 1. Perfarm A/T control unit

Check again.

input/output signal inspection. +

2. 1f N.G., recheck A/T control unit pin terminals for damage

INSPECTION END

or connection of A/T control unit harness connector.

SATEAIA

AT-50

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.