Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
AT automatic transmissionREPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

4

Reverse Clutch (Cont'd)

3. Remove drive plates, driven plates, retaining plate, dish plate and snap ring.

4. Remove snap ring from clutch drum while compressing clutch springs. Do not expand snap ring excessively. Oe Remove spring retainer and return spring.

6. Install seal ring onto oil pump cover and install reverse clutch drum. While holding piston, gradually apply com- pressed air to oil hole until piston is removed. @ Do not apply compressed air abruptly.

7. Remove D-ring and oil seal from piston. INSPECTION Reverse clutch snap ring and spring retainer @ Check for deformation, fatigue or damage. SATS844A Reverse clutch return springs

@ Check for deformation or damage. Also measure free length

and outside diameter. diameter inspection standard: Outer : Unit: mm (in) D Part No. g D Parts : Free length Q Spring 30505-41X02 | 19.69 (0.7752)

11.6 (0.457) SATB29A Reverse clutch drive plates Thickness @ Check facing for burns, cracks or damage. @ Measure thickness of facing. Facing Thickness of drive plate: Standard value

2.0 mm (0.079 in) Wear limit

1.8 mm (0.071 in) @ if not within wear limit, replace. Core plate Reverse clutch dish plate @® Check for deformation or damage. ee SATB45A

AT-111

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.