Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
AT automatic transmissionREPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Control Valve Upper Body (Cont'd)

ASSEMBLY

1. Lubricate the control valve body and all valves with A.T.F, install control valves by sliding them carefully into their =e : bores. AS AS ay @ Be careful not to scratch or damage valve body. — — a Se

wie) Oo

SAT&30A @ Wrap a small screwdriver with vinyl tape and use it to insert the valves into proper position.

Pressure regulator valve @ if pressure regulator plug is not centered properly, sleeve fo

cannot be inserted into bore in upper body.

/ lf this happens, use vinyl tape wrapped screwdriver to

Lightly push sleeve

center sleeve until it can be inserted.

® Turn sleeve slightly while installing.

in while turning it.

Center plug in spool bore

ir NESTS) ) saTs32a

Accumulator control plug @ Align protrusion of accumulator control sleeve with notch in plug. Z| @ Align parallel pin groove in plug with parallel pin, and install a accumulator control valve. ,

2. Install parallel pins and retainer plates.

= ficatt

SATB34A

AT-106

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.