Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
AT automatic transmissionREPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

I

Control Valve Upper Body (Cont'd)

: | DISASSEMBLY Remove valves at parallel pins.

1. Do not use a magnetic hand. @

Use a wire paper clip to push cut parallel pins.

a.

b. Remove parallel pins while pressing their corresponding plugs and sleeves. @ Remove plug slowly to prevent internal parts from jumping out.

c. Place mating surface of valve facedown, and remove internal parts. If a valve is hard to remove, place valve body facedown e@ and lightly tap it with a soft hammer. @ Be careful not to drop or damage valves and sleeves.

Soft hammer ~ SATB24A Remove valves at retainer plates.

2. Pry out retainer plate with wire paper clip.

a.

Retainer plate \

SATB25A AT-103

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.