Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

@ ICED | NG,

CHECK KICKDOWN SWITCH

Check the following items. Kickdown switch CIRCUIT. @ @ Harness continuity between A/T control unit and kick- down switch (Main harness) @ Harness continuity of ground

2. Check voltage between A/T circuit for kickdown switch control unit terminal @ and ground while depressing accelerator pedal slowly. (after warming up engine) Voltage: When releasing accelerator pedal: 3-8V When depressing accelerator yaw § A/T control unit pedal fully: 1V or less terminal OLK. | ‘ NG,

CHECK IDLE SWITCH

Perform self-diagnosis (Mode IV) for engine control. CIRCUIT. SAT754B ® Check voltage between A/T Check idle switch circuit.

control unit terminal @ and

O.K. N.G, ground in the same way as v ¥v kickdown switch circuit. Check harness Check idle Voltage: continuity switch circuit When releasing accelerator between A/T for engine pedal: 8 - 15V control unit control. — When depressing accelerator and idle switch, Refer to sec- pedal fully: 1V or less (Main harness) tion EF & EC. O.K. ¥ NG. Perform self-diagnosis again after

1. Perform A/T control unit driving for a while. input/output signal inspection,

2. 1f N_G., recheck A/T control O.K, unit pin terminals for damage x or connection of A/T control

INSPECTION END

unit harness connector.

AT-46

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.