Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 15

l/ o 0/0 cme OFF

SYMPTOM: Engine speed does not return to idle

Self-diagnosis

smoothly when A/T is shifted from D; to Ds

stat

with accelerator pedal released.

Vehicle does not decelerate by engine TTT

~~ ight

brake when changing overdrive switch to

“OFF” position with accelerator pedal - ~ Shade released.

b. i Vehicle does not decelerate by engine i saes®

brake when changing selector lever from

Mey Ly “D” to “2” range with accelerator pedal Throttle sensor and x7 released. throttle valve switch

i

Does self-diagnosis show damage

Yes

Check overrun clutch solenoid

to overrun clutch solenoid circuit circuit. — Refer to “Self- after cruise test? diagnosis” No 4 N.G. Check throttle sensor. — Refer = }|——*| Repair or replace throttle sensor. to section EF & EC. O.K. ¥

1. Remove oil pan. N.G.

2. Check A/T fluid condition. "| | 1. Remove control valve assem- bly. ~ Refer to “ON-VEHI- OK.

CLE SERVICE”,

*|

2. Check the following items.

@® Overrun clutch control valve Overrun clutch reducing valve O.K. @ SAT1I71B ® Overrun clutch solenoid 4] “ —

3. Disassemble A/T. 8/8 t 2 4, Check the following items. | @ Overrun clutch assembly a La @ Oil pump assembly - an ae a on} a * N.G. a = c ao a7 Check again. { co =o g »|

1. Perform A/T control unit : rn ' e--@ O.K.

2. If N.G., recheck A/T control

K input/output signal inspection. 0/8 1 ‘ i 2 + unit pin terminals for damage

INSPECTION END

or connection of A/T control unit harness connector.

D, (O0.D. OFF)

SAT?765B

AT-59

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.