Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › REPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual
AT automatic transmissionREPAIR FOR COMPONENT PARTS - Nissan 180SX S13 Workshop Manual

REPAIR FOR COMPONENT PARTS

REPAIR FOR COMPONENT PARTS

Oil Pump (Cont'd)

Side clearances Dial indicator @ Measure side clearances between end of oil pump housing and cam ring, rotor, vanes and control piston in at least four Straight edge places along their circumferences. Maximum measured val- ues should be within specified ranges. Pa - i 7 @ Before measuring side clearance, check that friction rings, O-ring, control piston side seals and cam ring spring are

Control Pw

y > — a removed. piston |? Ce , Gil pump Standard clearance: cam ring | Rotor housing Cam ring Vane

0.01 - 0.024 mm (0.0004 - 0.0009 in) SATG6ES7A Rotor, vanes, control piston ‘

0.03 - 0.044 mm (0.0012 - 0.0017 in) '

i. @ If not within standard clearance, replace oil pump assembly ‘ except oil pump cover assembly.

ee eg OTS Bs Seal ring clearance

Clearance Wy Seal ring

aes @ Measure clearance between seal ring and ring groove. Standard clearance:

0.10 - 0.25 mm (0.0039 - 0.0098 in) Wear limit:

0.25 mm (0.0098 in) @ If not within wear limit, replace oil pump cover assembly.

SATE5S8A ; ASSEMBLY

1. Drive oil seal into oil pump housing. ® Apply A.T.F. to outer periphery and lip surface. $T33200000

2. Install cam ring in oil pump housing using the following steps.

a. Install side seal on contro! piston. @ Pay attention to its direction — Black surface goes toward control piston. @ Apply petroleum jelly to side seal.

b. Install control piston on oil pump.

AT-93

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.