Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont’d)

OVERRUN CLUTCH SOLENOID CIRCUIT CHECK

Overrun clutch solenoid (eee

CHECK GROUND ciRCcUIT.

{N-S- | 7. Remove control valve assem-

a

1. bly. — Refer to “ON-VEHI-

CLE SERVICE”.

1~_Ferminal cord

2. Check the following items. r assembly

2. Disconnect terminal cord ® Overrun clutch solenoid, — 2t assembly connector in engine Refer to “Electrical Com- A/T control unit compartment. ponents Inspection’.

3. Check resistance between @ Harness continuity of terminal SAT76E8A terminal @) and ground. cord assembly a a Z STS. A : Resistance: 20 - 300 B] | OK. Sub- SY piscowercT harness €)

CHECK POWER SOURCE

NG Repair or replace harness

connector CIRCUIT. between A/T control unit and

1. terminal cord assernbly. (Main harness)

2. Disconnect A/T control unit 16-pin connector. SAT744B

3. Check resistance between

terminal @) and A/T control

unit terminal aD.

DISCONNECT = eg) a €) Resistance: Approximately 00 4, Reinstall any part removed. f’ harness O.K. connector P/L, ¥ Perform self-diagnosis after N.G.

1. Perform A/T control unit driving for a while. input/output signal inspection.

2. t€N.G., recheck A/T control O.K. = OSCONNECT ¥. unit pin terminals for damage tes 4 €>)

or connection of A/T control Ci unit harness connector, gi arr ee A pets - A/T control P/L —h unit terminal

INSPECTION END

SAT745B

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.