Workshop Manuals Factory service & repair Nissan and Datsun
01 cover02 A (intro)03 B (CA18DET/ECCS)04 C (driveline)05 D (body & frame)06 E (interior electric)07 F (misc. codes)08 manual notes09 Front cover10 CONTENTS11 GI General information12 MA maintenance13 EM engine mechanical14 LC lubrication & cooling15 EF &EC engine fuel & emission control system16 FE engine control fuel & exhaust systems17 CL clutch18 MT manual transmission19 AT automatic transmission20 PD prop shaft & diff carrier21 FA front axle & suspension22 RA rear axle & suspension23 BR brake system24 ST steering25 BF body26 HA heater & aircon27 EL electrical system
Nissan and Datsun Nissan 180SX S13 1989 Workshop Manual19 · AT automatic transmission
19 · Transmission

TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

Make
Nissan and Datsun
Model
180SX Nissan 180SX S13 1989 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual
AT automatic transmissionTROUBLE DIAGNOSES - Nissan 180SX S13 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 7

1]

SYMPTOM: Vehicle does not creep forward when

selecting ‘“D’, “2” or “1” range.

+ Li] |

Refill A.T.F.

>| O.K. ; 2 | i 7 N.G.

Check A/T fluid level again.

Check stall revolution with

—* | 1. Remove control valve assem- pyr “ON-VEHI Ret | selector lever in “BD” range. sate3ea| “ON-VE® bly. —

Refer to

— Refer to “STALL TESTING”.

CLE SERVICE”.

2. Check the following items.

O.K. ® Valves to control line pressure ~ ; : G ; (Pressure regulator valve, [NG Check line pressure at idle with

modifier valve, pilot valve and

“DTM range.

selector lever in

pilot filter) Refer to PRESSURE

® Line pressure solenoid

ESTING".

3. Disassemble A/T

OK. 4 |

4. Check the following items. NG ¥

1. Remove oil pan. , | © Oil pump assembly

2. Check A/T fluid condition. @ Forward clutch assembly @ Forward one-way clutch — Low one-way clutch ® Low & reverse brake assembly @ @ Torque converter Y : NG. : Us t,y| 1. Perform A/T control unit Check again. input/output signal inspection.

2. If N.G., recheck A/T control O.K. Vv unit pin terminals for damage

INSPECTION END

or connection of A/T control unit harness connector.

SATI7168 ee, oe Se On

AT-52

Parts & tools for this job For Nissan 180SX

As an Amazon Associate we earn from qualifying purchases.