Disassembly (Cont'd) - Nissan 180SX S13 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 180SX Nissan 180SX S13 1989 Workshop Manual
- Section
- General › Disassembly (Cont'd) - Nissan 180SX S13 Workshop Manual
Disassembly (Cont'd)
DISASSEMBLY |
Disassembly (Cont'd)
I I,
20. Remove band servo and accumulator components. |
a. Remove band servo retainer from transmission case.
SATO38B
b. Apply compressed air to oil hole until band servo piston comes out of transmission case. @ Hold piston with a rag and gradually direct air to oil hole.
c. Remove return springs.
} i ea} : 4 \ | ! | Ee if tot I SATOISB j i Ly fal
d. Remove springs from accumulator pistons B, C and D. | Soelen my
e. Apply compressed air to each oil hole until piston comes out. | @ Hold piston with a rag and gradually direct air to oil hole. Identification of accumulator pistons A B Cc D Identification of oil holes a b c d
SATO40B eee Remove O-ring from each piston.
f. i Front a> h (2 +3) (3 4.N >-R) { Accumulator Accumulator i piston B piston D 1 —_ a) (N -D) == } Accumulator Accumulator | piston C h piston A : t {| SATO93B7A r
21. Remove manual shaft components, if necessary.
Py
a. Hold width across flats of manual shaft (outside the trans- i TT ' mission case) and remove lock nut from shaft.
SATO41B AT-89
Parts & tools for this job For Nissan 180SX
- PARTTransmission filter kitSearch: Nissan 180SX transmission filter kit
- FLUIDAutomatic transmission fluidSearch: Nissan automatic transmission fluid
- TOOLFluid transfer pumpSearch: fluid transfer pump
As an Amazon Associate we earn from qualifying purchases.