Engine and automatic gearbox - models without air conditioning (page 10 of 10)

33. Connect expansion tank hose to inlet manifold and tighten clip.
34. Connect ECM vacuum pipe to inlet manifold.
35. Connect throttle cable to throttle cam.
36. Locate throttle cable adjusting nut in abutment bracket.
37. Ensure throttle cable is correctly routed and secure to clip on inlet manifold.
38. Connect brake servo vacuum pipe to inlet manifold.
39. Connect hose to fuel return pipe and secure with clip.
40. Clean union of fuel outlet pipe and fuel filter.
41. Connect fuel outlet pipe to fuel filter and tighten union to 28 Nm.

CAUTION: To prevent damage to fuel system pipes and components use two spanners when loosening or tightening unions.

42. Fit exhaust front pipe. See MANIFOLD & EXHAUST SYSTEMS, Repairs.
43. Fit evaporative emission cansiter. See EMISSION CONTROL, Repairs.
44. Connect the engine harness to main harness connector.
45. Connect multiplug to fuse box.
46. Fit positive leads to fuse box and secure with screws.
47. Fit fuse box inner cover.
48. Fit fuse box cover.
49. Connect multiplug to radiator cooling fan.
50. Position earth lead to bonnet locking platform, fit bolt and tighten to 9 Nm.
51. Connect heater hose to coolant outlet elbow and tighten clip.
52. Secure heater hose to clip on coolant rail.
53. Connect radiator bottom hose to coolant rail and tighten clip.
54. Connect radiator top hose to coolant outlet elbow and tighten clip.
55. Connect drive shafts to gearbox as detailed in Differential oil seal. See AUTOMATIC GEARBOX - ’CVT’, Repairs.
56. Position battery tray in vehicle.
57. Tighten 3 bolts securing battery tray to body, to 10 Nm.
58. Position engine compartment fuse box to body, fit bolt and tighten to 10 Nm.
59. Fit 4 bolts securing battery tray to body and tighten to 10 Nm.
60. Fit and tighten bolt securing engine compartment fuse box to battery tray.
61. Secure ABS fuse holder to battery tray.
62. Fit engine management relay module. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
63. Fit ECM. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
64. Fit air cleaner. See ENGINE MANAGEMENT SYSTEM - MEMS, Repairs.
65. Replace receiver/dryer. See AIR CONDITIONING, Repairs.
66. Adjust selector cable. See AUTOMATIC GEARBOX - ’CVT’, Adjustments.
67. Remove stand(s) and lower vehicle.
68. Recharge air conditioning system. See AIR CONDITIONING, Adjustments.
69. Refill gearbox with fluid. See AUTOMATIC GEARBOX - ’CVT’, Adjustments.
70. Refill cooling system. See COOLING SYSTEM - ’K’ SERIES, Adjustments.
71. If required: Refill engine with oil. See MAINTENANCE.
72. Bleed power steering system. See STEERING, Adjustments.
73. Adjust throttle and kickdown cable. See AUTOMATIC GEARBOX - ’CVT’, Adjustments.