Freelander Service Procedures
AUTOMATIC GEARBOX - JATCO
REPAIRS
44-11
Oil seal - torque converter
$% 44.17.11
Remove
1. Remove gearbox assembly.
2. Remove torque converter from gearbox.
Discard 'O' ring from gearbox input shaft.
3. Remove torque converter oil seal from
gearbox. Discard torque converter oil seal.
CAUTION: When removing torque converter
oil seal take care not to damage oil pump
housing.
Refit
1. Clean torque converter spigot.
2. Clean torque converter oil seal recess in
gearbox. Lubricate torque converter oil seal
with clean transmission fluid.
LUBRICANTS AND SEALANTS,
Lubrication.
3. Fit new torque converter oil seal using LRT-44-
024.
4. Lubricate and fit new 'O' ring to input shaft.
5. Fit torque converter.
6. Ensure converter is fully located in oil pump
drive by checking depth 'A' as illustrated.
l
KV6 models: Depth A = 4 mm.
l
Td4 models: Depth A = 27 mm.
7. Fit gearbox assembly.
M44 1659
A