Freelander Service Procedures
FUEL DELIVERY SYSTEM - PETROL
19-2-36 REPAIRS
10. Remove fuel rail.
CAUTION: Always fit plugs to open
connections to prevent contamination.
11. Remove and discard 'O' rings from injectors.
Refit
1. Lubricate new 'O' rings with castor oil and fit to
injectors.
2. Remove plugs from inlet manifolds.
3. Position injector harness to LH fuel rail and
secure with clips.
4. Position injectors and fuel rail to inlet manifolds.
5. Connect multiplugs to injectors.
6. Position injector cover - if fitted to RH fuel rail
and secure injector harness to protection cover
or to bosses on fuel rail with clips.
7. Fit bolts securing fuel rail to inlet manifolds and
tighten to 9 Nm (7 lbf.ft).
8. Up to 03MY: Position ignition coils to LH inlet
manifold.
9. Up to 03MY: Position earth lead, fit nuts and
bolts securing ignition coils to LH inlet manifold
and tighten to 9 Nm (7 lbf.ft).
10. Fit inlet manifold chamber.
- K SERIES KV6, REPAIRS, Seals - inlet
manifold chamber - up to 03MY.
11. Connect battery earth lead.
Fuel rail - KV6 - NAS
$% 19.60.04.99
Remove
1. Disconnect battery earth lead.
2. Remove inlet manifold chamber.
- K SERIES KV6, REPAIRS, Seals - inlet
manifold chamber - up to 03MY.
3. Remove underbelly panel.
4. Using a 3/8" socket bar raise ancillary drive belt
tensioner and release drive belt from alternator
and PAS pump pulleys.
5. Remove nuts and bolts securing alternator.
6. Release alternator and place aside.