Freelander Service Procedures
PANEL REPAIRS
77-2-46 REPAIRS
Refit
1. Secure vehicle harness to inner sill.
2. Fit headlining.
3. Fit rear roof panel finisher.
4. Fit seal and rear quarter vent.
Body quarter vent assembly - 3 door.
5. Secure carpet to inner sill.
6. Fit side door aperture seal.
7. Fit treadplate from side door aperture.
8. Fit rear body side casing.
REPAIRS, Trim casing - body side - rear - 3
door.
9. Fit rear seat.
SEATS, REPAIRS, Rear seat - LH.
SEATS, REPAIRS, Rear seat - RH.
10. Fit front door striker to 'B/C' post.
11. Fit front seat belt.
Automatic belt assembly - front - 3 door.
12. Fit rear wheel arch liner.
13. Fit rear wheel arch extension.
Wheelarch extension - rear wing part.
14. Fit road wheel(s) and tighten nuts to 115 Nm
(85 lbf.ft).
15. Connect all ECUs.
16. Connect alternator.
17. Connect battery earth lead.
'B/C' post reinforcement - 5 door
In this procedure, the rear outer body side panel and
the inner panel are replaced in conjunction with the
'B/C' post reinforcement.
Remove
1. Disconnect battery earth lead.
2. Disconnect alternator.
3. Disconnect all ECUs.
4. Remove rear door.
- rear - remove for access & refit.
5. Remove headlining.
6. Remove front seat belt.
Automatic belt assembly - front - 5 door.
7. Remove 'B/C' post lower finisher.
REPAIRS, Trim finisher - 'B' post - lower - 5
door.
8. Remove front door striker from 'B/C' post.
9. Remove front seat.
10. Remove rear seat.
SEATS, REPAIRS, Rear seat - LH.
SEATS, REPAIRS, Rear seat - RH.
11. Remove treadplate from side door aperture(s).
12. Remove side door aperture seal(s).
13. Release carpet from inner sill and position
aside.
14. Release vehicle harness from inner sill and
position aside.