Sunroof assembly - electrical, front and rear
- Make
- Land Rover
- Model
- Discovery Body Repair Manual
- Year
- 1995 on
- Section
- Repair › Sunroof assembly - electrical, front and rear
Chassis and bodySunroof assembly - electrical, front and rear
SUNROOF ASSEMBLY - ELECTRICAL, FRONT AND REAR
Service repair no - 76.82.59
Remove
Refer to sunroof components illustration J5483
- Ensure sunroof is in normally closed position.
- Disconnect battery negative lead.
- Remove headlining. See this section.
- Disconnect electric motor wiring plug. See this section.
- Remove screws and detach electric motor from clamping frame.
- Disconnect drain tubes from each side of clamping frame.
- Remove 13 fixings and remove clamping frame from upper frame.
- Remove upper frame assembly.
Refit
- Position upper frame assembly into roof aperture.
- Locate clamping frame and reconnect drain tubes.
- Loosely fit screws, centralise upper frame and clamping frame assemblies and then tighten screws.
- Reverse removal procedure.
Parts & tools for this job For 1995 Land Rover Discovery
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.