Refit windscreen glass

Refit WINDSCREEN GLASS

CAUTION: When refitting avoid trapping Service repair no - 76.81.01 electrical wiring. Information

29. Reverse removal procedure.
30. With assistance: Position dash panel and The following equipment is required: connect dash harness multiplugs to fusebox and main harness.
31. Reverse removal procedure. Ensure dash panel upper bracket studs are located before the 4 lower brackets.
32. Reverse removal procedure. Disconnect glovebox switch Lucars to ease fitting of relay bracket.

The following materials are included in the windscreen repair kit:

procedure must be completed within this time span to prevent the sealant oxidising, to effect a satisfactory joint.

repainted. Newly painted areas must then be left for 8 hours or more before applying adhesive sealant.

• Cutting wire and handles
• Windscreen repair kit (see Technical Bulletin). See Electrical Trouble Shooting Manual.Windscreen Glass Replacement.
• Sealant applicator gun.
• Suction cup lifters.
• Glass cleaning solvent - ’Betawipe’ Glass activator (yellow cap).
• Cotton buds.
• Glass primer - ’Betaprime’(green cap).
• Body primer - ’Betaprime’ paint/plastic primer (red cap).
• Betaseal Adhesive sealant.

NOTE: The adhesive sealant cures in 6 to 8 hours

• CAUTION: Once existing sealant is cut, the
• exposed surfaces oxidises in
• approximately 90 minutes. The refit

• CAUTION: If the windscreen aperture body
• flange shows signs of corrosion it must be
• treated with anti corrosion primer and