Workshop Manuals Factory service & repair Rover
01 Introduction02 General information03 Information04 Maintenance05 Engine - K806 Engine - K1607 Engine - K16 with VVC08 Engine - L Series09 Emission control10 Engine management system - MEMS11 Engine management system - EDC12 Fuel delivery system13 Cooling system - K Series14 Cooling system - L Series15 Manifold & exhaust systems16 Clutch17 Manual gearbox - R6518 Manual gearbox - PG119 Automatic gearbox - CVT20 Automatic gearbox21 Drive shafts22 Steering23 Front suspension24 Rear suspension25 Brakes26 Restraint systems27 Body28 Heating & ventilation29 Air conditioning30 Wipers & washers31 Electrical32 Instruments
Rover 200 Workshop Manual (1995-1999)31 · Electrical
31 · Electrical

Coaxial cable (page 2 of 3)

Make
Rover
Model
200 Workshop Manual
Year
1995–1999
Section
Repairs
ElectricalCoaxial cable · page 2 of 3
Diagram
  1. Remove 2 screws securing both sun visor clips.
  2. Remove clips.
Remove clips.
  1. Remove seals from top of both front door apertures.
  2. Remove 2 trim studs securing headlining to roof.
Remove 2 trim studs securing headlining to roof.
  1. Models with sun roof: Release sun roof switch finisher from headlining and remove.
  2. Carefully lower front edge of headlining to gain access to aerial.
Carefully lower front edge of headlining to gain access to aerial.
  1. Release coaxial cable from clip on roof.

Parts & tools for this job For 1995 Rover 200

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.