Models with ABS:

36. Secure harness grommets.
37. Locate rear of wing liners.
38. Position mudflaps and tighten screws.
39. With assistance pull harness into LH inner wing and secure in clips.
40. Secure bulkhead grommets.
41. Connect wiper motor multiplug and secure harness.
42. Connect multiplug to brake fluid level switch.
43. Connect multiplug to inertia fuel shut-off switch.
44. Connect multiplugs to fuse box.

Models with ABS:

45. Connect front LH ABS speed sensor multiplug and secure harness.

All models:

46. Connect multiplugs to engine harness.
47. Locate LH earth header and tighten nut.
48. Connect multiplugs to LH headlamp and headlamp levelling motor.
49. Connect multiplug to horn.
50. Connect multiplug to receiver/drier.
51. Connect multiplugs to cooling fans and secure harness.
52. Fit battery carrier. See this section.
53. With assistance pull harness into RH inner wing.
54. Secure front screen washer tube to harness.
55. Secure harness in retaining clips.
56. Fit PAS reservoir support bracket and tighten bolts.
57. Fit PAS reservoir.
58. Connect multiplug to bonnet switch.
59. Connect multiplugs to RH headlamp and headlamp levelling motor.

Models with ABS:

60. Connect multiplug to front RH ABS speed sensor and secure harness.
61. Connect multiplugs to ABS modulator.

All models:

62. Fit RH earth header and tighten nut.
63. Feed harness and washer tube to washer reservoir.
64. Fit washer reservoir. See WIPERS & WASHERS, Repairs.
65. Fit complete carpet. See BODY, Repairs.