Workshop Manuals Factory service & repair Rover
Rover Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition18 · Electrical
18 · Electrical

Safety indicator

Make
Rover
Model
600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
Section
Repairs › Safety indicator
ElectricalSafety indicator

SAFETY INDICATOR

Component Location Index

CAUTION:

  • All SRS electrical wiring harnesses are covered with yellow outer insulation.
  • Replace the entire affected SRS harness assembly if it has an open circuit or damaged wiring.

Before disconnecting the SRS wiring harness, turn the ignition switch off, disconnect the negative and positive battery cables, and wait at least three minutes, see SUPPLEMENTARY RESTRAINT SYSTEM

Note: LHD type is shown, RHD type is symmetrical.

Diagram of car rear showing locations of safety indicators, door switches, boot latch switch, boot light, and entry light timer circuit. Inset shows safety indicator symbols in gauge assembly. Labels A through H point to specific components. Figure number 86M 2112.
  1. Safety indicators (in gauge assy)
  2. Right front door switch
  3. Right rear door switch
  4. Boot latch switch
  5. Boot light
  6. Left rear door switch
  7. Left front door switch
  8. Entry light timer circuit (in the integrated control unit)

Parts & tools for this job For Rover 600

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.