Control Unit Input Test (page 3 of 4)
- Make
- Rover
- Model
- 600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
- Section
- Repairs
ElectricalControl Unit Input Test · page 3 of 4
| No. | Terminal | Test condition | Test: Desired result | Possible cause if result is not obtained |
|---|---|---|---|---|
| 11 | WHT/YEL and RED/BLU |
Connect the WHT/YEL and RED/BLU terminals with a jumper wire, and then turn the ignition switch ON (II) | Check the driver's window motor: It should run |
|
| 12 | BLU/BLK and BLU/YEL |
Connect the BLU/BLK and BLU/YEL terminals with a jumper wire, and the BLK/RED terminal to earth,then turn the igniton switch ON (II) | Check the front passenger window motor: It should run |
|
| 13 | GRN/BLK and GRN/YEL |
Connect the GRN/BLK and GRN/YEL terminals with a jumper wire, and the BLK/RED terminal to earth,then turn the igniton switch ON (II) | Check the left rear window motor: It should run |
|
| 14 | YEL/BLK and YEL[YEL/-WHT] |
Connect the YEL/BLK and YEL[YEL/WHT] terminals with a jumper wire, and the BLK/RED terminal to earth,then turn the igniton switch ON (II) | Check the right rear window motor: It should run |
|
| 15 | BLK/RED | Under all conditions | Check for continuity of the BLK/RED wire between the master power switch and key - off operation control unit: There should be continuity |
|
[ ]: RHD
Parts & tools for this job For Rover 600
- TOOLDigital multimeterSearch: automotive digital multimeter
- PARTAssorted fuse kitSearch: car fuse assortment kit
- TOOLWire crimper and connector kitSearch: wire crimper connector kit
Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.