Workshop Manuals Factory service & repair Rover
01 Information02 General data03 Engine04 Engine management system – PGM-Fi05 Cooling system, manifold and exhaust06 Clutch07 Manual gearbox08 Automatic gearbox09 Drive shafts10 Differential – manual gearbox11 Differential – automatic gearbox12 Steering13 Suspension14 Brakes and ABS15 Brakes – ABS BY416 Body17 Heating and ventilation18 Electrical19 Supplementary restraint system (SRS)
Rover Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition18 · Electrical
18 · Electrical

Control Unit Input Test (page 4 of 4)

Make
Rover
Model
600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
Section
Repairs
ElectricalControl Unit Input Test · page 4 of 4
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained
16 BLU and
BLK/GRN
Connect the WHT/YEL and RED/BLU terminals with a jumper wire, then turn the ignition switch ON (II) Connect an analogue ohmmeter to the BLU and BLK/GRN terminals: The meter needle should move back and forth alternately as the driver's window motor runs. ● Faulty pulser
● Faulty driver's window motor
● An open in the wire
17 GRN and
BLK/GRN
Connect the BLU/BLK and BLU/YEL terminals ,and the BLK/RED and BLK terminals with jumper wires, then turn the ignition switch ON (II) Connect an analogue ohmmeter to the GRN and BLK/GRN terminals: The meter needle should move back and forth alternately as the front passenger window motor runs. ● Faulty pulser
● Faulty front passenger window motor
● An open in the wire
18 RED and
BLK/GRN
Connect the GRN/BLK and GRN/YEL terminals ,and the BLK/RED and BLK terminals with jumper wires, then turn the ignition switch ON (II) Connect an analogue ohmmeter to the RED and BLK/GRN terminals: The meter needle should move back and forth alternately as the left rear window motor runs. ● Faulty pulser
● Faulty left rear window motor
● An open in the wire
19 PNK and
BLK/GRN
Connect the YEL/BLK and YEL[YEL/WHT] terminals ,and the BLK/RED and BLK terminals with jumper wires, then turn the ignition switch ON (II) Connect an analogue ohmmeter to the PNK and BLK/GRN terminals: The meter needle should move back and forth alternately as the right rear window motor runs. ● Faulty pulser
● Faulty right rear window motor
● An open in the wire

[ ]: RHD

Parts & tools for this job For Rover 600

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.