Workshop Manuals Factory service & repair Rover
Rover Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition18 · Electrical
18 · Electrical

Driver's Window Motor Test (page 3 of 3)

Make
Rover
Model
600 Rover 600 Repair Manual - Volumes 1 and 2 - 2nd Edition
Section
Repairs
ElectricalDriver's Window Motor Test · page 3 of 3
No. Terminal Test condition Test: Desired result Possible cause if result is not obtained
1 BLK Under all conditions Check for continuity to earth: There should be continuity
  • Poor earth (G501)
  • An open in the wire
2 WHT/YEL Under all conditions Check for voltage to earth: There should be battery voltage.
  • Blown No. 29(20A) fuse in the engine compartment fuse/relay
  • Blown No. 36,37,38 or 39 (20A) fuse in the engine compartment relay box
  • Faulty key – off operation control unit
  • Faulty power window relay
  • An open in the wire
BLU/BLK
GRN/BLK
YEL/BLK
3 RED/WHT and RED/YEL1 Connect the WHT/YEL and RED/WHT terminals with a jumper wire, and the RED/YEL1 terminal to earth, then turn the ignition switch ON (II). Check the driver's window motor: It should run.
  • Faulty driver's window motor
  • An open in the wire
4 BLU/WHT and BLU/GRN Connect the BLU/BLK and the BLU/WHT terminals with a jumper wire, and the BLU/GRN terminal to earth, then turn the ignition switch ON (II) Check the front passenger window motor: It should run.
  • Faulty front passenger window motor
  • An open in the wire
5 GRN/WHT-2 and GRN Connect the GRN/BLK and the GRN/WHT2 terminals with a jumper wire, and the GRN terminal to earth, then turn the ignition switch ON (II) Check the left rear window motor: It should run.
  • Faulty left rear window motor
  • Faulty left rear window switch
  • An open in the wire
6 YEL/WHT1 and YEL/GRN3 Connect the YEL/BLK and the YEL/WHT1 terminals with a jumper wire, and the YEL/GRN3 terminal to earth, then turn the ignition switch ON (II) Check the right rear window motor: It should run.
  • Faulty right rear window motor
  • Faulty right rear window switch
  • An open in the wire
7 BLK/RED Under all conditions Check for continuity in the BLK/RED wire between the master power switch and key – off operation control unit: There should be continuity.
  • An open in the wire.
8 BLU Connect the WHT/YEL and the RED/WHT terminals with a jumper wire, and the RED/YEL1 terminal to earth, then turn the ignition switch ON (II) Connect an analogue ohmmeter to the BLU terminal and body earth: The meter needle should move back and forth alternately as the driver's window motor runs
  • Faulty pulser
  • Faulty driver's window motor
  • An open in the wire
9 RED/BLK and RED Combination light switch ON, and dash lights brightness controller on full bright. Check for voltage between the RED/BLK and RED terminals: There should be battery voltage
  • Faulty combination light switch
  • Faulty dash lights brightness controller.
  • An open in the wire.

Parts & tools for this job For Rover 600

Links open Amazon search results in a new tab. As an Amazon Associate I earn from qualifying purchases.