Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

*1: 150 mm (5.91 in) - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › *1: 150 mm (5.91 in) - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEX*1: 150 mm (5.91 in) - Nissan 240SX 1991-1992 Workshop Manual

*1: 150 mm (5.91 in)

HEADLAMP

Assembly

1. Install headlamp motor, ball joint and link A (as one unit) on headlamp bracket.

2. While turning link B, install link A’s ball joint on headlamp housing’s ball joint.

3. Set distance between centers of upper and lower ball joints as shown in figure at left, and tighten lock nuts.

4. Assemble headlamp, finisher and lid.

SEL392L Headlamp

*1: 150 mm (5.91 in)

*2; 50 mm (1.97 in) wos

Lock nut

4 Motor side SEL393L Approx. 6.8 (0.268) Installation and Adjustment |

Before doing this, be sure to disconnect battery ground cable.

»

1. Install headlamp bracket to body temporarily. Approx. 6.0 1) Determine headlamp bracket location on body so that /

alignment between lid, hood, and fender looks straight.

Approx. 6.0 2) After adjusting alignment, tighten headlamp bracket to body.

Unit: mm (in)

ee SEL394L

2. Adjust lid alignment. Lid attaching @ Adjust lid, hood and fender for alignment while opening and bolts closing headlamp with motor manual knob. Use motor manual knob to open and close headlamp, and LULLLELLUi lull Ula adjust alignment while checking that lid is not interfering __ (yu with hood. LLL | LCLLLELLULLILLELLLL LL OU SEL395L 5

Adjust so that lid ee

is flush.

/ SEL3S96L

EL-38

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.