Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

ENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › ENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXENGINE MAINTENANCE - Nissan 240SX 1991-1992 Workshop Manual

ENGINE MAINTENANCE

ENGINE MAINTENANCE

Changing Engine Coolant (Cont'd)

13. Open radiator cap and air relief plug. Radiator_ TT

14. Fill radiator with coolant up to specified level. Follow instructions attached to anti-freeze container for mixing ratio of anti-freeze to water. Coolant capacity (With reservoir tank):

6.7 @ (7-1/8 US qt, 5-7/8 Imp qt) Pour coolant through coolant filler neck slowly to allow air in TUTTI TTT TT system to escape.

LTP TTTTTTTTTTTT

Te LITT TTTTTT rir rrr errr rrr errr itt SMA182B

TTT TTI A

15. Close air relief plug. Remove reservoir tank, drain coolant, then clean reservoir

16. tank. Install reservoir tank and fill it with coolant up to ‘““MAX”

17. level and then install radiator cap.

18. Run engine and warm it up sufficiently. MAX.

19. Race engine 2 or 3 times under no-load.

20. Stop engine and cool it down, then add coolant as neces- MIN. sary.

SMA412B

Checking Fuel Lines

Inspect fuel lines and tank for improper attachment and for leaks, cracks, damage, loose connections, chafing and deteri- oration. If necessary, repair or replace faulty parts. Engine Fuel line Fuel tank

SMA803A

Changing Fuel Filter

e— 3 mm (0.12 in)

CAUTION: Tighten high-pressure rubber hose clamp so that clamp end is 3 mm (0.12 in) from hose end. Ensure that screw does not contact adjacent parts.

SMA804A

WARNING: Before removing fuel filter, release fuel pressure from fuel line.

BE FUEL PRES FELEASE §

“WORK SUPPORT” mode to release fuel pres-

(i) (fe)

1. Perform

“FUEL PRESSURE RELEASE” in FUEL FUMP WILL STGP Bt! THUPHIHG START CURTHIS ICLE. sure to zero. CRAHE A FEM TIMES ArF-

2. Turn ignition switch off.

TER EMGIHE STALL.

| START SMA258C MA-10

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.