Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

PROPELLER SHAFT - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › PROPELLER SHAFT - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXPROPELLER SHAFT - Nissan 240SX 1991-1992 Workshop Manual

PROPELLER SHAFT

PROPELLER SHAFT

On-vehicle Service

PROPELLER SHAFT VIBRATION

If vibration is present at high speed, inspect propeller shaft runout first.

1. Raise rear wheels.

2. Measure propeller shaft runout at indicated points by rotat- ing final drive companion flange with hands. Runout limit: 0.6 mm (0.024 in) ‘ SPD901 Propeller shaft runout measuring points: Unit: mm (in) 3S63A-T Center vA bearing Journal | @)Ll L— Cc A B Journal 3S63A-R Seng Coupling

DistanceModel3S63A-T3S63A-R
DistanceA155 (6.10)175 (6.89)
165 (6.50)165 (6.50)
Cc185 (7.28)185 (7.28)

A B Cc SPD872 If runout exceeds specifications, disconnect propeller shaft

3. at final drive companion flange; then rotate companion flange 180 degrees and reconnect propeller shaft. Runout limit: 0.6 mm (0.024 in)

4. Check runout again. If runout still exceeds specifications, replace propeller shaft assembly.

5. Perform road test.

APPEARANCE CHECKING

@ Inspect propeller shaft tube surface for dents or cracks. lf damaged, replace propeller shaft assembly. lf center bearing’ is noisy or damaged, replace center e@ bearing.

Removal Transmission @ Draw out propeller shaft from transmission and plug up rear end of transmission rear extension housing.

SPD359 PD-6

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.