INTERIOR AND EXTERIOR - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › INTERIOR AND EXTERIOR - Nissan 240SX 1991-1992 Workshop Manual
INTERIOR AND EXTERIOR
INTERIOR AND EXTERIOR
Exterior (Cont'd)
(Q) Door weatherstrip (3) Rear sight shield Apply buty! sealant where necessary while installing the weath LL washer
SBF215E SBF217E
Back door window upper and side molding
Back window upper and side molding (Coupe)
Basically the same as windshield upper and side (Fastback) Bonded on back door glass side. molding.
(5) Back door window lower molding
() Back window lower molding (Coupe) (Fastback) It is mounted with screws. — Molding fastener Molding
(2 Trunk lid weatherstrip
(Set it when windshield glass is installed.) Molding clip (9 places) Trunk lid Body panel weatherstrip
Vehicle center
Double-faced
Body panel
adhesive tape [When in- stalling fas- tener, heat body panel and fastener to approx. 30 to 40°C (86 to SBF401B 104° F)]. There is a marking at vehicle center. SBF216E
BF-27
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.