SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › SUPER HICAS SYSTEM — Trouble Diagnoses - Nissan 240SX 1991-1992 Workshop Manual
SUPER HICAS SYSTEM — Trouble Diagnoses
SUPER HICAS SYSTEM — Trouble Diagnoses
Diagnostic Procedure 11
SYMPTOM:
Inhibitor switch (A/T) or neutral switch (M/T) input is not
present. START
v O.K.
CHECK CONNECTOR CONTINUITY.
| Poor connector connec- | * Disconnect control unit connector and tion SST430B reconnect it firmly. Conduct self-diag- nosis. N.G.
[wy] ’ B
YMONITOR ¥yNO FAIL
Okm/h- O.K.
CAR SPEED (REF)
,| Replace control unit.
CHECK CONTROL UNIT INPUT
STEERING ANG
Lg° |
NEUTRAL SIG
ON SIGNAL.
STOP LAMP SW
OFF Set CONSULT in DATA MONI-
PKB/CLUTCH SW
ON TOR mode.
NEUTRAL SW
ON
ENG REV
UNDER 1500 ON-OFF display
HICAS SOL
RO.O0A OR ee Measure voltage variations | RECORD between control unit terminals 44 and @4 when shift lever is
YY MONITOR ¥¥ NO FAIL
moved from P to any other posi- FAILSAFE/V: OFF tion (A/T) or shift lever is moved FAILSAFE NON
WARNING LAMP
OFF from neutral to any other posi- tion (M/T). Voltage: OV — Approximately 12V N.G. | RECORD Vv Check inhibitor switch or neutral switch and harness. SST728B
®) CONNECT HS.
SST747B
ST-67
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.