Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CHECK AND ADJUSTMENT — On-vehicle - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CHECK AND ADJUSTMENT — On-vehicle - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCHECK AND ADJUSTMENT — On-vehicle - Nissan 240SX 1991-1992 Workshop Manual

CHECK AND ADJUSTMENT — On-vehicle

CHECK AND ADJUSTMENT — On-vehicle

Front Wheel Alignment

Before checking front wheel alignment, be sure to make a preliminary inspection (Unladen’*). *: Fuel, radiator coolant and engine oil full. Spare tire, jack, hand tools and mats in designated positions.

Inside

Y/ SFA575B

PRELIMINARY INSPECTION

1. Check tires for wear and improper inflation.

2. Check wheel runout. Wheel runout: Refer to S.D.S. Check front wheel bearings for looseness. Check front suspension for looseness. Check steering linkage for looseness. On Check that front shock absorbers work properly by using the standard bounce test.

7. Check vehicle posture (Unladen).

CAMBER, CASTER AND KINGPIN INCLINATION

Camber, caster and kingpin inclination are preset at factory and cannot be adjusted.

1. Measure camber, caster and kingpin inclination of both right and left wheels with a suitable alignment gauge. Camber (Unladen): —1°30’ to 0° Caster (Unladen): 6°00’ - 7°30’ Kingpin inclination (Unladen): 12°30’ - 14°00’ SFA948A

2. If camber, caster and kingpin inclination are not within specifi- cation, inspect and replace any damaged or worn front sus- pension parts.

TOE-IN

1. Draw a base line across the tread. @ After lowering front of vehicle, move it up and down to eliminate friction, and set steering wheel in straight-ahead position.

SMA123

FA-7

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.