Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER BLOCK - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER BLOCK

CYLINDER BLOCK

Inspection

PISTON AND PISTON PIN CLEARANCE

1. Measure inner diameter of piston pin hole ‘‘dp’’. Standard diameter ‘‘dp’’:

20.987 - 20.999 mm (0.8263 - 0.8267 in)

SEM149B

2. Measure outer diameter of piston pin ‘‘Dp’’. Standard diameter “‘Dp”’:

20.989 - 21.001 mm (0.8263 - 0.8268 in)

3. Calculate interference fit of piston pin to piston. dp — Dp = 0 - 0.004 mm (0 - 0.0002 in) If it exceeds the above value, replace piston assembly with pin.

Micrometer SEM821B

PISTON RING SIDE CLEARANCE

Side clearance: Top ring

0.040 - 0.080 mm (0.0016 - 0.0031 in) 2nd ring Feeler

0.030 - 0.070 mm (0.0012 - 0.0028 in) gauge Max. limit of side clearance:

0.1 mm (0.004 in) If out of specification, replace piston and/or piston ring assem- Feeler gauge O.K. bly. Ring SEM249C

PISTON RING END GAP

End gap: Piston Top ring ne

0.28 - 0.52 mm (0.0110 - 0.0205 in) 2nd ring

0.45 - 0.69 mm (0.0177 - 0.0272 in) Oil ring

0.20 - 0.69 mm (0.0079 - 0.0272 in) Max. limit of ring gap:

1.0 mm (0.039 in) If out of specification, replace piston ring. If gap still exceeds the limit even with a new ring, rebore cylinder and use oversized piston and piston rings. Refer to S.D.S.

EM-39

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.