Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Diagnostic Procedure 30 (Cont'd)

INSPECTION START |

@ MIXTURE RATIO TEST ®

ACCELERATE TO 2000 Vv

RPM AND HOLD THEN

O.K.Ay INSPECTION END.

CHECK OVERALL FUNCTION.

TOUCH START.

1) Start engine and warm it up cy sufficiently. 2) Perform “MIXTURE RATIO 1800 2000 2200 TEST” in “FUNCTION TEST’ mode with CONSULT.

[ next

|| START | OR SEF632L = 1) Start engine and warm it up sufficiently.

wx MONITOR #NO FAIL []

2) Make sure that ‘‘M/R F/C MNT” in “DATA MONITOR” CAS-RPM(REF) _ 2087rpm

M/R F/C MNT

— LEAN mode indicates ‘“‘RICH”’ and “LEAN” periodically more than 5 times during 10 sec- onds at 2,000 rpm. OR 1) Start engine and warm it up [ RECORD | sufficiently. 2) Run engine at about 2,000 SEF996K rpm for about 2 minutes under no-load. 3) Set E.C.U. diagnosis mode to Mode II. 4) Keep engine speed at 2,000 rpm and make sure that RED L.E.D. on E.C.U. and check engine light on instrument panel go on and off more Check engine light than 5 times during 10 sec-

RED L.E.D.

onds. SEF621K N.G. B. ’ 4e Be N.G. || Repair harness or con-

CHECK INPUT SIGNAL CIRCUIT.

| nectors. 1) Turn ignition switch ‘OFF’. 2) Disconnect exhaust gas sensor har- ness connector and E.C.U. harness connector. 2) Check harness continuity between terminal @ and E.C.U. terminal @®. @& [2] Continuity should exist. O.K. SEF942I Vv Replace exhaust gas sensor.

EF & EC-117

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.