Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

1992_240sx: diagram

TROUBLE DIAGNOSES

Electrical Components Inspection (Cont'd)

A/T CONTROL UNIT INSPECTION TABLE

(Data are reference values.)

Terminal No.ItemConditionJudgement standard
No.ItemConditionstandard
h t i W: en accelera or pedal is released15-25V
1Line pressure solenoidafter warming up engine.
1Line pressure solenoidWhen accelerator pedal is depressed0.5V or less
fully after warming up engine.
9Line pressure solenoidWhen accelerator pedal is released after warming up engine.5. 14V
9Line pressure solenoid (with dropping resistor)after warming up engine. When accelerator pedal is depressed
(with dropping resistor)When accelerator pedal is depressed . . fully after warming up engine.0.5V or less
When A/T check lamp ison ‘1V or less
3O.D. OFF indicator lamp‘ When A/T check lamp . is not on.Battery voltage
4Power sourceWhen ignition switch is turned to “ONe] ON”.Battery voltage
4Power sourceWhen ignition switch is turned to “OFF”.Vorl or less
5Lock-up solenoidWhen A/T is performing lock-up.8- 15V
5Lock-up solenoidWhen A/T is not performing lock-up. | 1V or less
When shift solenoid A is operating. (When driving in “D,” or “Dg”.)Battery voltage ¥ volted
6 |Shift solenoid AWhen shift solenoid A is not operating.1V or less
operating.1V or less
(When driving in “D,.” or “D3””.)
When shift solenoid B is operating. (When driving in ““D, ” or “D4 ".)Batt it amery wolrage
7Shift solenoid BWhen shift solenoid B is not
7Shift solenoid BWhen shift solenoid B is not operating. (When driving in “D3” or “’D4’”.)1V or less
(When driving in “D3” or “’D4’”.)
When timing solenoid is operating. (When driving in “’D,; ” or ““D,”’.)Battery voltage y a
(When driving in “’D,; ” or ““D,”’.)y a
8Overrun clutch solenoidWhen timing solenoid is not
operating.1V or less
(When driving in ““D,” or “D3 ’’.)

AT-70

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.