GENERAL INFORMATION - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › GENERAL INFORMATION - Nissan 240SX 1991-1992 Workshop Manual
GENERAL INFORMATION
DESCRIPTION — Refrigeration System V-5 Variable Displacement Compressor
GENERAL INFORMATION
The V-5 variable compressor differs from previous units in that the vent temperatures do not drop too
1. far below 5°C (41°F) at a suction temperature of less than 20°C (68°F) while the engine is running at speeds less than 1,500 rpm. This is because the V-5 compressor provides a means of ‘“‘capacity”’ control. The V-5 variable compressor provides refrigerant control under varying conditions. During the winter season when ambient temperatures are low, it sometimes does not produce high refrigerant pressure discharge (compared to previous units) when used with automobile air conditioning systems. Air bubbles in the sight glass also may not disappear. However, these symptoms are not a matter of concern. When charging the refrigerant, always use a service can. Extreme care should be taken not to charge the refrigerant excessively. A “clanking” sound may occasionally be heard during refrigerant charge. The sound indicates that the tilt angle of the swash plate has charged and is not a problem. In air conditioning systems which are equipped with the V-5 compressor, the clutch remains engaged unless the system main switch, fan switch or ignition switch is turned OFF. When the acceleration cut system is operating or when the amount of refrigerant is insufficient, the clutch is disengaged to protect the compressor. A constant range of suction pressure is maintained when engine speed is greater than a certain value. It normally ranges from 147 to 177 kPa (1.5 to 1.8 kg/cm?, 21 to 26 psi) under varying conditions. In previous compressors, however, suction pressure was reduced with increases in engine speed. lf the ambient temperature drops below approx. 22°C (72°F), the ambient temperature switch turns OFF and F.I.C.D. operation stops. The reason is that the variable displacement compressor is controlling the volume of air, and when the ambient temperature is low and refrigerating load becomes small, the compressor requires less torque, which eliminates the need for the F.1.C.D., idling
r.p.m. increase.
HA-8
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.