ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ON-VEHICLE SERVICE - Nissan 240SX 1991-1992 Workshop Manual
ON-VEHICLE SERVICE
ON-VEHICLE SERVICE
Control Valve Assembly and Accumulators Inspection
1. Remove oil pan and gasket and drain A.T.F.
Remove oil strainer.
2.
3. Remove control valve assembly by removing fixing bolts and disconnecting harness connector. Bolt length and location
Bolt symbol
mm (in) G24 g
@® 33 (1.30). 45 (1.77)
4. Remove solenoids and valves from valve body if necessary.
5. Remove terminal cord assembly if necessary.
Remove accumulator A, B, C and D by applying compressed
6. air if necessary. Hold each piston with rag. Reinstall any part removed. Always use new Sealing parts. ere
SATO74B Revolution Sensor Replacement oh
1. Remove rear engine mounting member from body panel while supporting A/T with jack. =o-S —
2. Lower A/T assembly as much as possible. ra a
—_—- eo) Q—B—-9 s) ‘SAT800B AT-7
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.