Preliminary Check (Cont’d) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › Preliminary Check (Cont’d) - Nissan 240SX 1991-1992 Workshop Manual
Preliminary Check (Cont’d)
SUPER HICAS SYSTEM — Trouble Diagnoses
Preliminary Check (Cont’d)
6. Touch “START.” Mactive test = [J After simulated drive condition has continued for 5 minutes, it ; will automatically cancel and CONSULT unit will then show ENBIION
“TEST IS INTERRUPTED TO AVOID OIL TEMP RISE” display.
== =MONTOR ===
To cancel this mode during self-diagnosis, simply touch “CANCEL”.
R119 RO.58A
STEERING ANG
HICAS SOL
CANCEL | SST708B
7. While running engine at speeds greater than 2,000 rpm, turn steering wheel 180° to the left and right from the neu- tral position. Ensure that rear wheels steer in response to rotation of steering wheel.
When CONSULT is not used: &
1. Turn key switch ‘OFF’.
2. Set HICAS system in self-diagnosis mode. ' (1) Turn ignition switch ‘““OFF’’. (2) Set shift lever to ‘‘P” or ‘‘N” position (A/T model), or ‘Neutral’ position (M/T model). (3) Turn ignition switch “ON”. (4) Immediately start engine. (5) Turn steering wheel from left to right (at least 20° from the neutral position) 5 times or more, then depress foot brake pedal at least 5 times all within 10 seconds after ignition switch has been turned “‘ON”’.
3. Set steering wheel to a point approximately 10° from the neutral position and check to ensure that rear wheels turn to the left and right alternately.
SST477B
ST-44
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.