Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

REAR COVER INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › REAR COVER INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXREAR COVER INSTALLATION - Nissan 240SX 1991-1992 Workshop Manual

REAR COVER INSTALLATION

CHARGING SYSTEM —Alternator— Assembly (Cont'd)

REAR COVER INSTALLATION

(1) Fit brush assembly, diode assembly, regulator assembly and stator. (2) Push brushes up with fingers and install them to rotor. Take care not to damage slip ring sliding surface.

SEL964N

Service Data and Specifications (S.D.S.)

ALTERNATOR

‘TypeLR180-729
Nominal rating V-A12-80
Ground polarityNegative
Minimum revolution under no-load (When 13.5 volts is applied) rpmLess than 950
(When 13.5 volts is applied) rpmLess than 950 More than 23/1,300
Hot output current A/rpmMore than 63/2,500
More than 77/5,000
Regulated output voltage V14.1 - 14.7
. Minimum length of brush mm {in)6.0 (0.236)
Brush spring pressure N (g, oz)1.000 - 3.432
Brush spring pressure N (g, oz)1.000 - 3.432 (102 - 350, 3.60 - 12.34)
Slip ring minimum outer diameter mm (in)26.0 (1.024)

EL-27

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.