Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

WINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › WINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXWINDSHIELD AND WINDOWS - Nissan 240SX 1991-1992 Workshop Manual

WINDSHIELD AND WINDOWS

WINDSHIELD AND WINDOWS

Windshield REMOVAL INSTALLATION

After removing moldings,

@ Use genuine Nissan Sealant kit or equivalent. Follow instructions furnished with

remove glass. it. After installation, the vehicle should remain stationary for about 24 hours. Cutting sealant Do not use sealant which is more than 12 months past its production date. Do not leave cartridge unattended with its cap open. Keep primers and sealant in a cool, dry place. Nissan recommends that they are stored in a refrigerator. @ Be sure to install moldings.

WARNING: Clean bonding surface thoroughly. Keep heat or open flames away as Glass side primers are flammable. SBFO034B Body side

CAUTION: Be careful not to scratch glass when removing.

SBF413B Body side Glass side — __4

Install dam rubber & spacers with double-faced adhesive tape.

Install spacers to panel with double-faced tape. Vehicle Spacer center 3 al @) e063 25 (0.98) | Body panel “Tht ; Dam rubber Unit: mm (in) |. joint portion Approximately adhesive ‘500 | a : Spacer mounting 8 mm (0.31 in) tape Vehicle center | portion SBF196E (Spacer should be installed at slit portion of dam rubber.) SBF198E y N Apply primer A. Install molding fastener. When installing it, heat body panel and fastener to approx. 30 to 40°C (86 to Glass

Upper & side molding

; 104°F) oF . Lr fastener Fastener VA Panel Double-faced Lower side Glass adhesive tape of glass SBF197E SBF719C

CAUTION: Allow primers to dry for 10 to 15 minutes before proceeding to the next step.

<<

BF-72

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.