Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

TROUBLE DIAGNOSES

Self-diagnosis (Cont'd)

LOCK-UP SOLENOID CIRCUIT CHECK

Lock-up

solenoid

cord assembly |

N.G.

CHECK GROUND CIRCUIT.

9?

1. Remove oil pan. |— Terminal » 1

— Refer to “ON-VEHICLE

SERVICE”. {

2. Check the following items.

@ Lock-up solenoid — Refer to

2. Disconnect terminal cord 5 “Electrical Components A/T control unit assembly connector in engine Inspection”. compartment. SAT971B @ Harness continuity of terminal

3. Check resistance between

terminal ©) and ground.

cord assembly. Solenoids AA) Resistance: 10 - 2022 harness 5 TS. O.K. 1B Vv connector DISCONNECT € | @® N.G.

CHECK POWER SOURCE

Repair or replace harness between A/T control unit and terminal cord assembly.

1. & —

2. Disconnect A/T control unit = SAT974D connector.

3. Check resistance between

terminal () and A/T control

Zune Solenoids

unit terminal 6).

5) harness TS. co DISCONNECT connector Resistance: > 5) Approximately 022.

4. Reinstall any part removed. O.K. Vv N.G. Perform self-diagnosis after

1. Perform A/T control unit driving for a while. input/output signal inspection.

2. If N.G., recheck A/T control O.K. unit pin terminals for damage Vv or connection of A/T control

INSPECTION END

A Ee unit harness connector. DISCONNECT

[__c7untT [cl CONNECTOR |

5

GY/R

SAT975D

AT-51

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.