AXLE HOUSING - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › AXLE HOUSING - Nissan 240SX 1991-1992 Workshop Manual
AXLE HOUSING
REAR AXLE — Wheel Hub and Axle Housing Disassembly (Cont'd)
AXLE HOUSING
@ Attach a drift on outer shell of bushing as shown in figure at left, remove bushing using arm bushing remover. When placing axle housing in a vise, use wooden blocks or $T38280000 ( - ) copper plates as pads. / Axle housing \
@ Ensure axle housing bore is free from scratches or de- formities before pressing bushing into it. @ Attach bushing to chamfered bore end of axle housing and press it until it is flush with end face of axle housing.
SRA112A Inspection
WHEEL HUB AND AXLE HOUSING
@ Check wheel hub and axle “housing for cracks by using a magnetic exploration or dyeing test. @ Check wheel bearing for damage, seizure, rust or rough operation. Check rubber bushing for wear or other damage. @ Replace if necessary.
Assembly Place hub on a block. Attach a drift to inner race of wheel bearing and press it into hub as shown in figure at left. Be careful not to damage grease seal.
Drift YW), Mg
SRA113A | RA-12
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.