Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › TROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXTROUBLE DIAGNOSES - Nissan 240SX 1991-1992 Workshop Manual

TROUBLE DIAGNOSES

1992_240sx: diagram

TROUBLE DIAGNOSES

Consult (Cont'd) FUNCTION

Diagnostic modeFunction
This mode enables a technician to
| Work supportadjust some devices faster and more accurately by following the
indications on the CONSULT unit.
Self-diagnostic resultsSelf-diagnostic results can be read and erased quickly.
Data monitorInput/Output data in the control unit
Data monitorInput/Output data in the control unit can be read.
Mode in which CONSULT drives
Active testsome actuators apart from the
Active testsome actuators apart from the control units and also shifts some
parameters in a specified range.
E.C.U. part numberE.C.U. part number can be read.
Conducted by CONSULT instead of
Funstion testa technician to determine whether
WORK SUPPORT MODEeach system is “OK” or “NG”.
WORK ITEMCONDITIONUSAGE
THROTTLE SENSORCHECK THE THROTTLE SENSOR SIGNAL.When adjusting throttle sensor
ADJUSTMENTADJUST IT TO THE SPECIFIED VALUE BY ROTATINGinitial position
THE SENSOR BODY UNDER THE FOLLOWING
CONDITIONS.
e IGN SW “ON”
e ENG NOT RUNNING
e ACC PEDAL NOT PRESSED
IGNITION TIMINGe IGNITION TIMING FEEDBACK CONTROL WILL BEWhen adjusting initial ignition
ADJUSTMENT*HELD BY TOUCHING ‘‘START”’.timing
AFTER DOING SO, ADJUST IGNITION TIMING WITH
A TIMING LIGHT BY TURNING THE CRANK ANGLE
SENSOR.
AAC VALVE ADJUSTMENTSET ENGINE RPM AT THE SPECIFIED VALUE UNDERWhen adjusting idle speed
THE FOLLOWING CONDITIONS.
e ENGINE WARMED UP
e NO-LOAD
FUEL PRESSURE RELEASEe FUEL PUMP WILL STOP BY TOUCHING “START”’When releasing fuel pressure
WHEN IDLING.from fuel line
CRANK A FEW TIMES AFTER ENGINE STALLS.

EF & EC-47

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.