Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

DESCRIPTION — Refrigeration System - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › DESCRIPTION — Refrigeration System - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXDESCRIPTION — Refrigeration System - Nissan 240SX 1991-1992 Workshop Manual

DESCRIPTION — Refrigeration System

DESCRIPTION — Refrigeration System

V-5 Variable Displacement Compressor (Cont'd)

Operation

1. Operation control valve Operation control valve is located in the suction port (low-pressure) side, and opens or closes in response to changes in refrigerant suction pressure. Operation of the valve controls the internal pressure of the crankcase. The angle of the swash plate is controlled between the crankcase’s internal pressure and the piston cylinder pressure. Maximum cooling Refrigerant pressure on the low-pressure side increases with an increase in heat loads. When this occurs, the control valve’s bellows compress to open the low-pressure side valve and close the high-pressure side valve. This causes the crankcase’s internal pressure to equal the pressure on the low-pressure side and the cylinder’s internal pressure to be greater than the crankcase’s internal pressure. Under this condition, the swash plate is set to the maximum stroke position.

Discharge port

Crankcase

Suction port Low-pressure valve: Open

Bellows

Valve position for lowering crankcase pressure

Cylinder pressure 4 Crankcase pressure > Spring pressure Forces needed to increase stroke RHA258B

HA-10

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.