ADJUSTMENT (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
- Make
- Nissan and Datsun
- Model
- 240SX Nissan 240SX 1991-92 Workshop Manual
- Section
- General › ADJUSTMENT (Model R200) - Nissan 240SX 1991-1992 Workshop Manual
ADJUSTMENT (Model R200)
ADJUSTMENT (Model R200)
Side Bearing Preload (Cont’d)
5. Install the side bearing caps in their correct locations and torque the bearing cap retaining bolts. Specification: 88 - 98 N-m (9 - 10 kg-m, 65 - 72 ft-lb)
6. Turn the carrier several times to seat the bearings.
7. Measure the turning torque of the carrier at the ring gear retaining bolts with a spring gauge, J-8129. Specification:
34.3 - 39.2 N (3.5 - 4 kg, 7.7 - 8.8 Ib) of pulling force at the ring gear bolt.
8. If the carrier turning torque is not within the specification range, increase or decrease the total thickness of the side bearing adjusting washers until the turning torque is correct. If the turning torque is less than the specified range, install washers of greater thickness; if the turning torque is greater than the specification, install thinner washers. See the S.D.S. section for washer dimensions and part numbers.
9. Record the total amount of washer thickness required for the correct carrier side bearing preload.
10. Remove the carrier from the final drive housing, saving the selected preload washers for later use during the assembly of the final drive unit.
Pinion Gear Height and Pinion Bearing Preload
1. Make sure all parts are clean and that the bearings are well lubricated.
2. Assemble the pinion gear bearings into the pinion preload shim selector Tool, J-34309.
SPD769
PD-19
Parts & tools for this job For Nissan 240SX
- TOOLTorque wrenchSearch: 3/8 inch torque wrench
- TOOLSocket setSearch: socket set metric
- BOOKHaynes manualSearch: Haynes manual Nissan 240SX
As an Amazon Associate we earn from qualifying purchases.