Workshop Manuals Factory service & repair Nissan and Datsun
01 QUICK REFERENCE INDEX02 Front Cover03 Foreword04 Table of Contents05 General Information06 Windshield Header Trim07 Windshield Header Molding08 Weatherstrips and Retainers09 Rear Seat10 Quarter Trim Panel11 Quarter Window and Regulator12 Door and Door Window13 Seat Belts14 Back and Quarter Belt Moldings15 Headliner Assembly16 Top Cover Assembly17 Backlite Assembly18 Stay Pads, Side and Rear19 No. 1 Bow20 No. 2 Bow21 No. 3 Bow22 No. 4 Bow23 Rear and Side Rail24 Hydraulic System25 Electrical26 Deck Lid Hinge and Trunk Trim27 Body Structural28 Index29 Back Cover30 QUICK REFERENCE CHART
Nissan and Datsun Nissan 240SX 1991-92 Workshop Manual01 · QUICK REFERENCE INDEX
01 · General

CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual

Make
Nissan and Datsun
Model
240SX Nissan 240SX 1991-92 Workshop Manual
Section
General › CYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual
QUICK REFERENCE INDEXCYLINDER HEAD - Nissan 240SX 1991-1992 Workshop Manual

CYLINDER HEAD

CYLINDER HEAD

Inspection (Cont’d)

CAMSHAFT SPROCKET RUNOUT

1. Install sprocket on camshaft.

2. Measure camshaft sprocket runout. Runout (Total indicator reading): Limit 0.15 mm (0.0059 in)

3. If it exceeds the limit, replace camshaft sprocket.

SEM875B

VALVE GUIDE CLEARANCE

1. Measure valve deflection in a parallel direction with rocker arm. (Valve and valve guide mostly wear in this direction.) Valve deflection limit (Dial gauge reading): Intake

0.16 mm (0.0063 in) Exhaust

0.2 mm (0.008 in)

2. If it exceeds the limit, check valve to valve guide clearance.

a. Measure valve stem diameter and valve guide inner diam- eter. .

b. Check that clearance is within specification. Valve to valve guide clearance: Unit: mm (in)

StandardLimit
Intak mane0.020 - 0.053 (0.0008 - 0.0021)0.08 (0.0031 (0.0081)
Exh xhaust0.040 - 0.073 (0.0016 - 0.0029)4 (0.004 0.1 (0.004)

c. If it exceeds the limit, replace valve or valve guide.

SEM298D

VALVE GUIDE REPLACEMENT

1. To remove valve guide, heat cylinder head to 120 to 140°C (248 to 284°F).

SEMO08A EM-25

Parts & tools for this job For Nissan 240SX

As an Amazon Associate we earn from qualifying purchases.